1. Where do I seat the TSX, Tipped TSX and LRX bullets?
When loading a Barnes TSX, Tipped TSX or LRX bullet, your rifle may prefer a bullet jump of anywhere between (a minimum of) .050” up to .250” or more. This distance off the lands (rifling), aka "jump" may be limited to the rifles throat length, magazine length and bullet length.
When selecting the cartridge overall length (COAL) we recommend starting with a minimum “jump” of .050” off of the lands. You can test different seating depths and find a “sweet spot” that your particular firearm prefers. We suggest working in at least .025” increments as follows seating the bullet deeper to allow a further jump. Your test plan could look something like this:
1st group- .050” jump
2nd group- .075” jump
3rd group- .100” jump
4th group- .125” jump
5th group- .150“ jump
6th group- * see below
HB电子游戏官网 This length can be determined by using a “Stoney Point Gauge” or other methods. You do not have to seat the bullet at, or on one of the cannelure rings. Remember there are many factors that may control or limit the seating depth for your application. You may find that you need to start at around 0.150” off the lands and are not able to get any closer due to limiting factors including proper neck tension and magazine length.
HB电子游戏官网 *In rifles that have long throats you may be limited on how close you are able to get the bullet to the lands. In these instances, it is not uncommon to find the best accuracy with a jump of .200” or more.
HB电子游戏官网 This jump may possibly stay the same regardless of powder or charge weight within a given rifle. If preferred accuracy is not obtained, we certainly recommend trying another powder, for the powder type and charge greatly affects the overall accuracy of each individual firearm.
FYI- An accurate load requires a bullet with the proper consistent case neck tension which leads to more constant pressures and velocities.
2. Twist rate
The twist rate is measured by how many inches of bullet travel down the barrel it takes the rifling to twist the bullet one full turn. This measurement is called the “rate of twist” and is expressed as a ratio, such as 1:7, which means the bullet spins one full rotation in seven inches of barrel travel. The lower the ratio the faster the rate of twist.
3. How accurate is the TSX?
HB电子游戏官网In testing we have found the TSX bullet to be very accurate. Handloader Magazine often prints their test results in which Barnes TSX bullets produce accuracy results that are just as good, if not better than match-grade bullets. A number of shooting schools use VOR-TX ammunition loaded with TSX bullets as their ‘go to’ brand to verify accuracy when a student’s rifle and ammunition does not produce acceptable results.
If you are interested in the most recent data for cartridges and/or bullet weights/styles not listed on this page, contact Barnes Consumer Service department to inquire about recommended loads and approximate timing for the data to be made available via email at email@example.comHB电子游戏官网 or by phone at 800.574.9200.
ATTENTION:HB电子游戏官网 New reloading data must be opened as a PDF document in an up-to-date compatible PDF viewer. If the load charges appear to be blacked out follow these steps:
If this does not solve the issue, customer service will send you a copy of the data. Contact them via email at firstname.lastname@example.org or by phone at 800.574.9200.